Bdi2000 setup software

It would be nice to do again some little project with the , which is a nice processor - and with the BDI, which allows for debugging, it is more fun Last night I hooked up some old disks I had from previous PCs and found some stuff. Somewhere is more, I know it I have finally got around to looking at this BDI device I have two of them actually.. I think the above files from xdel.

It's possible that mine are already correct for my target device, but it'd still be useful to have all the proper tools. Well, I can at least confirm that one of my BDIs has something half useful on it, but not quite.

I need mpc, not Also, the GUI tool from xdel. Still looking for help. After looking more closely at the. Not sure what the point of those files is. Although there are slight differences between each of the. They aren't standalone and the firmware and logic files are still necessary to utilize them.

I'm not sure why Abatron felt the need to build separate. I believe the files I need for my rev. C unit are b20qp4gd. Thank you, kind soul s I think you're going to need to try to find a contact at ntb. I actually did send an email to Fabian, but unfortunately I didn't get a response. In my case I am lucky, because the BDI has the correct FW for my target mpc5xx , so I just need to use the config tool and put a cfg etc on a tftp server.

It's designed to support CPU It's a decent solution, not brilliant, but it does its work. Then I will have to write the full software Quote from: legacy on November 02, , pm. Quote from: carl0s on November 04, , am. Which protocol? Which mode? Quote from: carl0s on November 02, , pm.

Quote from: nathana on November 05, , pm. The following users thanked this post: nathana. No disks though. But also I am stuck as I cannot find these files as per the Abatron manual pdf that states: The following files are on the diskette. So the specific files for the MPC8xx targets.

Found it. Well, not quite those files, but enough to get me going again. Fohdeesha Contributor Posts: 45 Country:. Hey all - sorry if this isn't the appropriate section, I figured it's the closest I could find! I have a couple arm devices that need JTAG'ing in order to be unbricked. I purchased a BDI on ebay however it's useless as it does not have the appropriate firmware on it.

I contacted Abatron but they went bankrupt and totally shut down, their site doesn't even exist anymore - so it seems this firmware or any bdi firmware is unobtainable now Will be in huge debt to anyone who happens to have a copy lying around! I can send you the MPC85xx firmware in exchange if it could be of any use to you! With Update the old version will be deleted and automatically the newest will be loaded on the device. Quote from: Fohdeesha on May 10, , am.

Quote from: andersm on May 10, , am. I'm about ready to give up and buy one of those seggers, which is annoying as I'll only need it once. I have an Abatron at work that is in storage - I can check if its accompanying CD has the firmware updater and. That will not happen until Monday, though. The information is there not to be an axiomatic truth, but instead each speck of data must be slowly inhaled while carefully performing a deep search inside oneself to find the true metaphysical sense If it has the ARM updater that would be amazing!

I'll paypal you some beer money. I looked my pod for accompanying software CD to no avail - I suspect I have a brick here. At any rate, did you contact these guys? They may still have something lingering around. Quote from: rsjsouza on May 21, , pm.