Ford ranger manual transmission swap




















Many owners have went with synthetic transmission fluid hoping to extend the life of the transmission. Synthetic fluid handles high temperatures and pressures better then conventional fluids. After time, the slave cylinder fails to release the clutch completely.

Unfortunately there is no easy fix here as the transmission must be removed to replace the combination slave cylinder and throwout bearing. There is some confusion about these two transmissions and some believe they are one in the same. The new model has a detachable bellhousing, a main case and extension housing, all made of aluminum. The mainshaft and countershaft are supported by tapered bearings with shims under the races to set endplay.

All speeds are fully synchronized with helical-cut gears. The speed gears all run on needle bearings on the shafts. Contact us. Close Menu. Forums TECH 2. JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding. Manual transmission conversion. Thread starter Pacc Start date Sep 9, Pacc Member. The transfer case is mechanical so I suppose the most on that end other than an adapter plate, may have to change the t case input shaft.

I can figure out the clutch and accessories on my own, may need help with disconnecting the TCM and removing it from the main computer. Ford for whatever reason has decided to not repond to my emails. Any legit knowledge is appreciated! I side with Ford. The automatic is just too good. Msfitoy Well-Known Member. All 2. The only modification that will need to be done is to the floor plate.

You can either cut it to fit the new shifter or you can remove the front seats and pull the carpet back to get to the 4 8mm bolts that hold it on and swap in the one from your donor. All that may be left is to trim the carpet. If you take your time, the piece that you trim out can be used to replaced the gap it will leave behind the shifter. A transmission that came off a 2. The 2. This means that the 2. This causes the tranny cross member to be moved 2.



0コメント

  • 1000 / 1000