How to give manual ip in windows 7

Enter the values. Press [ ] to increase the value and press [ ] to decrease the value. When you have finished entering all the values, press [OK] for the setting to take effect. Check out the latest WiFi Routers. Get information, documentation, videos and more for your specific product. Ask the Community. Need to Contact Support? See Support Options. Contact Support. Figure 2. The Administrative Command Prompt Windows 7. At the Administrative Command Prompt , type netsh interface ip show config , which will display the network adapters available on your system and their names.

Note down the name of the network adaptor for which you would like to set the static IP address. Figure 3. Following is the command used to configure the interface with the IP address of Next, we configure our primary DNS server using the netsh command with the following parameters:.

If for any reason the DNS server is not reachable therefore not validated , you might see the following error:. Select Local area connection from the items under Network and Dial-up connections ; this opens with the general information on Local area connection status. Click on the Properties button. The Local area connection properties dialog opens listing all the protocols. Click on the Advanced button at the bottom of the dialog. Click Add button next to the displayed IP addresses to add an IP address with a corresponding sub-net mask.

You will have to re-start the system for the changes to take effect. The procedure to configure virtual IP addresses in bulk under Windows is given below. When you select this, the right side data content will display IP address and properties. Double click on the IP address field. This opens a Multi-String editor where the virtual IP addresses you want have to be keyed in. You can cut and paste to minimise the time for large number of IPs.

When you have finished entering the IP addresses, select the subnetmask field This opens a Multi-String editor where the subnetmask you want have to be keyed in. Enter the same number of subnetmasks